I think it is working but it is more trades than I expected.
For range of 2-10 is 4732 trades out of 27000 bars
For range 2-100 is 1600 trades
For range 2-1000 is 700 trades
I don't know if this sounds right
https://fxdreema.com/shared/C1Bme5gPb
This was results with all blocks switched off it was the same when they were on
I isolated the first condition, starting with candle 1 high greater than candles 2-10 highest price and then candle 1 high greater than candles 2-100 highest price and got 2100 vs 1600 trades and watching the strategy tester it was taking too many trades I don't think the filter is working properly.
I connected only the blocks for sell signals. My first block filtering for the high of candle 1 must be greater than the high of candle 2-10 is not working because if I disconnect the block I get 1323 trades vs 1328 trades with the block attached so it isn't really doing anything. Tested in xauusd 2020 until now. Adjusting the candle range doesn't do anything e.g 2-5 vs 2-20.
The problem was using custom price fraction not level for sell now . could you check to see if first condition makes sense for sell side?
https://fxdreema.com/shared/Y8FZhNGnb
If I change candle range from 2-5 to 2-20 I would expect less trades but I am getting the same amount of trades. The condition should be if candle 1 high is higher than candle 2-5 high then pass, changing this to 2-20 makes no difference so I don't think its filtering.
left hand side is hammer for buys and right hand side is inverted hammer for sells they have opposite conditions but sells never execute and buys only seem to work for usdjpy
Attached is the mq4 file.
Simple eat that takes short positions when there is an inverted hammer and candle 1 high is higher than 2-5.
On backtesting with mt4 ea takes no positions.
I disconnected the buy hammer condition from buy now so it only does sells.
Edit: Also the buys included version only seems to execute only on jpyusd (1660 trades all longs), 3 trades on eurusd and none on usdchf all from 2020-2024.
is this correct? I changed end candle to 6. What is difference between using candle ID and price value? Which is correct?
Thanks.
As the title says I am trying to create a condition where if candle 1 is less than candles 2 to candle 5, the image is what I have so far but I am not sure if it is using a candle range or if it is just comparing candle 1 to the single candle, candle 5.
If it is just using candle 1 < candle 5 (alone) how to I create the condition candle 1 < (candle 2, 3, 4, 5)/
Thanks
