I found bug in "Z to A" in "Loop direction" in "For each object".
when my object name is A01 A02 ..... A09 .... everything is ok
but when my object name A010 ..... there is a problem. How come it calculate that A010 is less than A09?
I can not get the value of object A010 ...A011 ...A012 .... so on, the value is stop at A09
then it start to get value again when my object name in A091 .... something like this.
Do you understand me?
sorry for my english
thank you. I've never use custom code. could you guide me a little bit please... how to code 
If I have 100 variables, how can I sum them up easy? (not sum by using "fomular" block one by one)
How to limit "number" of trading symbols? if I drag EA into 28 pairs but want to limit only 4 pairs that activate it's condition first to trade. ?
What is the block "Send file to FTP" ... and how to use it? Do you have example?
Thank you very much Roar.
Is it possible to connect variables between 2 running MT4(different broker)?
How to use Terminal Variables? I want to connect variables between 2 EA ...
How to use Terminal Variables?
Zigzag High Low ID are work but why Higher High, Lower Low are not work?
Thank you, this what I am curious. But my question is I want EA to open order "once per condition". how to do? sometime my EA meet conditions and it open order then TP already but at the same time it open another order under old conditions, I want just one order per condition.
If I have many trades order which consist of profit orders and loss order, I want to close all trades when my equity is less than my balance too much? like I start with 1000 balance then I run EA until sometime my balance is 2000 but my equity is 1600 (-20%), I want to close all to make my balance is 1600 then I run EA again.