Posts made by jstap

I found out how you can do it: https://fxdreema.com/shared/LkhGA5Icd

You can't, even if you convert, the values are different:

What are your 2 oscillators? Normally this would require a special indicator, or a coder. But it might be possible to turn the value 0 to100 into 0 to -100, show what you use and I'll have a look.

Add a shared link, you can get this from candle ID or time, just depends on how you need your EA set up.

I do it like this: https://fxdreema.com/shared/kA8586vyd

You can just use the trace block:

Not necessarily, but would depend on what the indicator is using them for. I can't help more than that.

As long as all being true this should work, but it relies on a tick happening on candle open like many things, so I will often set a condition that can happen over a little time.

You have names in blocks, this may stop, the set market block working. When it works on one, then add the set allowing that to set market in all blocks, and see if that works.

This is quite simple, time filter to stop trading before session end, market properties high and low for range. create your project and add a shared link for any problems.

ID 1 candle high is > ID 2 high, if you want instant, ID 0 X> ID 1 high, draw arrow

Yes to separate buy & sell, I don't know how to stop band walking, is the biggest problem with BB, you will have to find logic that will prevent unwanted trades.

Code works better for this, https://fxdreema.com/shared/9fq1qWdGb, I think this is what you want.

Rename 1 of your flags, at the minute they are both the same, so when 1 of your conditions is correct, buy and sell flags, can create a trade.

You have to decide what condition recreates the pending, share you project link to look at.

Tree 1: 1,2,3,5,6,14,15 Tree 2: the rest, both trees, should remain separate.

In your indicator, buffer 1, do you have a price value? If you do not know, put the buffer in a comment block, so you can visually check what it shows on back test.

As you have it in the picture, all is correct, so all connected on by orange, in two separate trees, just reset when needed.

This looks like it should work, strip back to one condition, then test, once you know it's working, add another. Until you can verify what is or isn't working.

unix is seconds from 1970, not a price (vertical not horizontal), test this until you get a number you can check with your cross hair