Posts made by jstap

In here you will see how I use HA, https://fxdreema.com/shared/1UDRbblwe, standard doesn't always work. Use and test with this, you can then adjust to do all you want.

Some blocks are MT4/MT5 specific, when converted these don't change, change these blocks and all should work.

Say what's not working and add your latest shared project link.

No as I showed you, there is no value so that line can't be used. Report a bug with admin and see what can be done.

Rarely need it, if you remove it will work the same.

Set the no trade block to any symbol, this will only allow 1 trade at a time across all symbols:

I don't know but you can't use that line

Only 1 line has a value: https://fxdreema.com/shared/g3EFaU8sb

Add a shared link

Yes condition block, SO is < or >, value of line.

If you look in here you will see how to get HA to, work on FX. https://fxdreema.com/forum/topic/17790/have-had-to-use-icustom-to-get-heiken-ashi-to-work?_=1689794184494

place each one with a different group.

You can set to 0.8, if defaults to 10, set back to 0.8

On MT you can select smaller, depends on what is shown on live chart. You can also use current.

Save the time

This depends on broker and asset

Could be a terminal problem, could be any one of the blocks, or your setup. Add a shared link, I will have a look and see if I spot everything.

Have been trying to print arrows using Heiken Ashi, couldn't get to work correctly, one off the values is different to the data window value, in this project I have used iCustom to get it to work: https://fxdreema.com/shared/Mnapg7Mje

Why ?, if A is > B then check if B is > C, some combination will get what you want.

I don't have one, you could use ZigZag but this is not easy. Otherwise you will have to find a indicator to do it.